How to use Band-It Edging:
1. Prepare Surface Edge: Fill any large holes – Sand rough spots – Remove sawdust – Cut edging 1/2” longer than surface to be covered.
2. To apply edging: Preheat iron on "cotton setting", position edging, slowly press iron over length of veneer, check to see if glue is melting (NOTE: Use Kraft paper or aluminum foil to protect iron bottom).
3. For Bonding: While still hot, press veneer down with wood block or roller (Make a mistake? Simply reheat and reapply!)
4. To Trim Edge: Allow veneer to cool completely, trim any excess with a BAND-IT Edge Trimmer, razor blade or file, and sand smooth and finish as desired.
It is pre-glued and ready to be ironed on!